ONLINE SHOP

HOW TO USE ReFa HYDRA CLEAR

Introduction

When using the device for the first time

  • Test it first on a small patch of skin on the inside of your arm.

Frequency and duration of use

  • It is recommended to use the device once a week, and no more than twice a week.
  • Use for approximately 3 minutes at a time. (30 seconds on the right side of the nose, 30 seconds on the left side of the nose, and about 2 minutes total for the forehead, cheeks, and chin).
  • Begin by using the device for short periods. Prolonged use may cause skin irritation or damage.

Areas of use

  • This device can be used around the nose area, forehead, cheeks, and chin.
    Do not use it on any part of your body other than your face.

How to remove the attachment

Gently rotate your wrist away from your skin.

  • Rotate your wrist

Avoid using the device in the following ways.

  • Rubbing the skin aggressively

    Rubbing the skin aggressively

  • Applying excessive pressure

    Applying excessive pressure

  • Prolonged use on the same area. Repeated suction on the same area.

    Prolonged use on the same area
    Repeated suction on the same area

Standard way to use

Before using the device

1. Remove makeup and cleanse your face.

  • Use after cleansing your face and before applying lotion or emulsion.
  • It is also recommended to warm your skin using a steamed towel or facial steamer.

Preparing the device

1. Fill the water tank with water or lukewarm water (30°C to 40°C).

  • Do not fill with anything other than water or lukewarm water.

  • Remove the water tank from the main unit.

  • Fill the tank with water to approximately 90%.

  • Insert the tube into the water supply side, and attach the water tank securely.

2. Change the attachment to suit the area you are using it on.

  • When removing the attachment from the main unit, turn it counterclockwise until it stops.

  • There are protrusions in two places.

  • When attaching, align the protrusions on the main body with the indentations on the attachment, then press in and turn clockwise.
  • The attachment can be changed while the device is in operation.
  • If the attachment is difficult to remove, use gloves with good grip. (such as rubber gloves or non-slip gloves)

Suction

1. Press and hold the Power Button (about 1 second) to turn the power on.

  • A beep will sound and the attachment will light up blue.

  • The lowest level lamp will light up. White light

2. Press the Level Button to select the suction level.

  • When using the device for the first time, start with level 1 and gradually increase the level while observing the condition of your skin.

  • The level lamp indicates the suction level that is currently set.

After turning on the power, press your fingertip or palm against the attachment and wait until water starts coming out before using it on your face. The device will not perform as intended if used without water coming out.

3. Suction the areas of your face where you are concerned about pore impurities.

  • Place the attachment on your skin and then quickly remove it by turning your wrist.

Around the nose area

Forehead, cheeks, chin

Do not tilt the device excessively when there is water in the water tank. Doing so may cause water to spill out.

4. Press and hold the Power Button (about 1 second) to turn the power off.

  • A beep will sound and all the light indicators will go out.
  • After use, wipe the moisture off your skin with a clean cloth and moisturize with lotion or other products.
  • The power will turn off automatically after it has been on for about 5 minutes.
  • Clean the device after use. See the cleaning method here